Dear SCO Customer, Support Level Supplement (SLS) OSS657A, the Minimum PIT Count Supplement for OpenServer 5.0.6, addresses the following problem: Some systems running SCO OpenServer 5.0.6 on CPUs over 1 gigahertz may experience periodic system pauses that can be resumed by console keyboard activity. The problem is caused by the Programmable Interrupt Timer (PIT) being programmed to assert and deassert itself so fast that the CPU's attempt to service the interrupt is unsuccessful. This leads to an endless loop of spurious interrupts which can only be broken by a legitimate interrupt (such as a keystroke on the console keyboard). The problem has been observed on certain HP and Dell Xeon systems. SLS OSS657A is a Boot Time Loadable Driver (BTLD) which will reprogram the PIT timer to a larger minimum value which will allow for stable interrupt servicing. Software Notes and Recommendations ---------------------------------- SLS OSS657A can be used with: SCO OpenServer Release 5.0.6 Installation Instructions ------------------------- 1. Download the OSS657A media image file from: ftp://ftp.sco.com/pub/openserver5/oss657a.btld.Z Place the file in the /tmp directory, and extract it to a formatted floppy with this command: zcat /tmp/oss657a.btld.Z > /dev/fd0 2. To use the BTLD with an already-installed system, go to single-user mode. Mount the BTLD floppy and use btldinstall(ADM) to install it: # mount -r /dev/fd0 /mnt # btldinstall /mnt # umount /mnt Relink the kernel and reboot. 3. The problem has rarely been observed during operating system installation (initial system load, or ISL). If you have a system which is difficult to install due to continual pauses during ISL, start ISL with the bootstring: Boot : defbootstr link=mpcs If your installation requires other BTLD(s), the syntax is "link=driver1,driver2". For example: Boot : defbootstr link=mpcs,lsil,ivga You do not need to follow step 2 on such systems. The ISL process performs the btldinstall(ADM) step for you. If you have questions regarding this SLS, or the product on which it is installed, please contact your software supplier.