Dear Caldera Customer, Support Level Supplement (SLS) OSS647A, the Sdsk Supplement for OpenServer Release 5.0.5, installs an updated Sdsk driver with the following improvements: - Corrects a potential panic when a single SCSI disk is simultaneously opened and closed by multiple processes. The OpenServer disk partitioning scheme allows a disk to be subdivided into partitions and divisions; see hd(HW) for details. Due to a programming error, it was possible for the system to panic if several subdivisions of a single disk were opened and/or closed at exactly the same time. Three specific cases were observed, although others could exist. The observed cases involved (1) several UNIX filesystems on a single disk being checked at the same time by fsck(ADM), (2) several Unix filesystems being created at the same time with mkfs(ADM), and (3) several DOS filesystems being listed at the same time with dosdir(C). The panic occurred in kernel function "dkfree". - Corrects a potential panic when a certain type of error is returned by the SCSI host adapter driver. This resulted in a panic during a restore of a vdisk RAID5 array. The panic occurred in kernel function "Sdsk_setparam". - Adds the variable Sdsk_set_WCE in /etc/conf/pack.d/Sdsk/space.c. When this is set to 1, the driver turns on the WCE (Write-Cache Enable) feature of all attached hard disks. This can improve disk writing speed. When 0, each drive retains its default setting which is controlled by the drive's own firmware or the host adapter BIOS. Software Notes and Recommendations ---------------------------------- SLS OSS647A should only be installed on: SCO OpenServer Release 5.0.5 with Release Supplement 505A (rs505a) and SLS OSS497C installed. Note: the multiple open/close problem also existed in SCO OpenServer Release 5.0.6, and was corrected by Release Supplement 506A (rs506a). Installation Instructions ------------------------- 1. Download the OSS647A media image file (oss647a), place the file in the /tmp directory, and rename the file by typing: mv /tmp/oss647a /tmp/VOL.000.000 2. Run the Software Manager with the command: # scoadmin software or double-click on the Software Manager icon in the desktop. 3. Pull down the "Software" menu and select "Install New". 4. When prompted for the host from which to install, choose the local machine and then "Continue". 5. In the "Select Media" menu, pull down the "Media Device" menu. Select "Media Images", then choose "Continue". 6. When prompted for the "Image Directory", enter "/tmp" (or the directory where you placed the VOL file in step 1) and choose "OK". 7. When prompted to select software to install, make sure that the "OSS647A" entry is highlighted. Choose "Install". 8. Installation of SLS OSS647A is now complete. To exit the Software Manager, select "Exit" from the "Host" menu. Removal Instructions -------------------- Patches must be rolled back in the reverse order in which they were installed on a per-component basis. That is, if SLS OSS647A is not the most recent patch applied to the UNIX component of the product, you will have to roll back all patches applied after SLS OSS647A prior to rollback of SLS OSS647A patch. To remove SLS OSS647A, take these steps: 1. Log in as root. 2. Execute the command: # scoadmin software or double-click on the Software Manager icon in the desktop. 3. Highlight "OSS647A: Sdsk supplement". 4. Pull down the "Software" menu and select "Remove Software". 5. Once the removal finishes, quit the Software Manager. Removal of SLS OSS647A is now complete. If you have questions regarding this SLS, or the product on which it is installed, please contact your software supplier.