Dear SCO Customer, Support Level Supplement (SLS) OSS627A, the Intel Pentium Pro and Pentium II Microcode Driver, provides support for the downloading of new microcode to Intel Pentium Pro and Pentium II processors, as well as support for erasure of the Pentium III Processor Serial Number (PSN). Other Pentium III issues may also be addressed by this SLS. SLS OSS627A is intended for use on these products: SCO OpenServer Release 5.0.0 SCO OpenServer Release 5.0.2 Installation Instructions ------------------------- 1. Download the OSS627A media image file (oss627a), place the file in the /tmp directory and rename the file by typing these commands: mv /tmp/oss627a /tmp/VOL.000.000 2. Run the Software Manager with the command: # scoadmin software or double-click on the Software Manager icon in the desktop. 3. Pull down the "Software" menu and select "Apply Patch". 4. When prompted for which host to install from, choose the local machine and then "Continue". 5. When prompted to select the media device: If you are installing this SLS from diskette media, select the appropriate floppy disk drive and then "Continue". Proceed to step 6. If you are installing this SLS from media images per step 1, select "Media Images", then "Continue". When prompted for the "Image Directory", enter "/tmp" (or the directory where you placed the VOL file in step 1, and then select "OK". 6. When prompted to select software full or partial installation, choose "Full". 7. During installation of OSS627A, you may choose to have the Pentium III Processor Serial Number (PSN) erased. This change is not permanent; each time the system is powered on the PSN is restored, and each time the operating system boots, it is erased (if this option is selected). Your selection can be changed by removing and reinstalling SLS OSS627A. 8. Once the installation finishes, quit the Software Manager. Installation of SLS OSS627A is now complete. The changes will take effect the next time you reboot the system. 9. Log in as root on tty01, and shut down the system: # shutdown -g0 -y After shutting down and rebooting the machine, application of the SLS is complete. Removal Instructions -------------------- Note: Patches must be rolled back in the reverse order in which they were installed on a per-component basis. SLS OSS627A, the Intel Pentium Pro and Pentium II Microcode Driver, consists of a patch to the SCO Unix component. If this component was patched after SLS OSS627A was installed, then you will have to roll back the later patch before you can roll back the SLS OSS627A patch. 1. Log in as root. 2. Execute the command: # scoadmin software or double-click on the Software Manager icon in the desktop. 3. Highlight "OSS627A: Pentium microcode update". 4. Pull down the "Software" menu and select "Rollback Patch". 5. Once the removal finishes, quit the Software Manager. Removal of SLS OSS627A is now complete. You must reboot your system for the removal to take effect. 6. As root on tty01, shut down the system: # shutdown -g0 -y After shutting down and rebooting the machine, removal of the SLS is complete. If you have questions regarding this SLS, or the product on which it is installed, please contact your software supplier.