Dear SCO Customer, Support Level Supplement (SLS) OSS623A, the SMP Supplement for SCO OpenServer Release 5.0.5 and 5.0.4, addresses a problem with the SMP component of SCO OpenServer Release 5.0.5 and 5.0.4 operating systems. SLS OSS623A corrects the following problem: On certain systems, one or more devices will fail to respond following installation of SCO Symmetric Multiprocessing Support. An example of such a device is one of the SCSI host adapters on systems based on the Intel S450NX motherboard, such as the Gateway ALR 9200. SLS OSS623A replaces the following file: /etc/conf/pack.d/apic/Driver.o Software Notes and Recommendations ---------------------------------- SLS OSS623A should only be installed on: SCO OpenServer Enterprise System Release 5.0.5 SCO OpenServer Host System Release 5.0.5 SCO OpenServer Desktop System Release 5.0.5 with Symmetric Multiprocessing Support, Release Supplement 505A, and SLS OSS497C SCO OpenServer Enterprise System Release 5.0.4 SCO OpenServer Host System Release 5.0.4 SCO OpenServer Desktop System Release 5.0.4 with Symmetric Multiprocessing Support, Release Supplement 504C, and SLS OSS469D Installation Instructions ------------------------- 1. Prepare the media for installation. Download the OSS623A media image file (oss623a file), place the file in the /tmp directory and rename the file by typing these commands: mv /tmp/oss623a /tmp/VOL.000.000 2. Run the Software Manager with the command: # scoadmin software or double-click on the Software Manager icon in the desktop. 3. Pull down the "Software" menu and select "Install New". 4. When prompted for which host to install from, choose the local machine and then "Continue". 5. When prompted to select the media device, choose "Media Images, then "Continue". When prompted for the "Image Directory", enter "/tmp" (or the directory where you placed the VOL file), and then select "OK". (If you are installing this SLS from diskette media, select the appropriate floppy disk drive and then "Continue". Proceed to step 6.) 6. When prompted to select software to install, ensure that the "OSS623A" entry is highlighted. Choose "Install". 7. Once the installation finishes, quit the Software Manager. Installation of SLS OSS623A is now complete. The changes will take effect the next time you reboot the system. 8. Log in as root on tty01, and shut down the system: # shutdown -g0 -y After shutting down and rebooting the machine, application of the SLS is complete. Removal Instructions -------------------- Notes: Patches must be rolled back in the reverse order in which they were installed on a per-component basis. 1. Log in as root. 2. Execute the command: # scoadmin software or double-click on the Software Manager icon in the desktop. 3. Highlight "The SMP Supplement for SCO OpenServer Release 5.0.5 and 5.0.4". 4. Pull down the "Software" menu and select "Remove Software". 5. Once the removal finishes, quit the Software Manager. 6. As root on tty01, shut down the system: # shutdown -g0 -y After shutting down and rebooting the machine, application of the SLS is complete. If you have questions regarding this SLS, or the product on which it is installed, please contact your software supplier.