Dear SCO Customer, The enclosed Support Level Supplement (SLS) OSS463B, the Multiple SCSI Install N0 Supplement, allows for the installation of SCO OpenServer 5.0.4 operating systems on computers with CD-ROM drives attached to secondary host adapters. Previously, it was only possible to use these CD-ROM drives by configuring them after the installation of the operating system. SLS OSS463B is intended for use on these products: SCO OpenServer Enterprise System Release 5.0.4 SCO OpenServer Desktop System Release 5.0.4 SCO OpenServer Host System Release 5.0.4 SCO OpenServer Internet FastStart Release 5.0.4 SLS OSS463B consists of a replacement N0 and an additional BTLD diskette. The N0 is to be used in place of the original N0 floppy provided with the installation media. The BTLD is to be used at install time if any of the drivers shown below are required for installation: alad Adaptec 294x (7870 & 7880 Chip) arad Adaptec 274x (7770 Chip) mdac Mylex Disk Array Controller slha Symbios Logic (formerly NCR MPD) 53c8xx Host Adapters wd Enhanced IDE, ATAPI Interface (for tapes and CD-ROMs) The changes made in this SLS only affect installation procedures; there is no post installation requirement to install software from the replacement N0 or BTLD. INSTALLATION INSTRUCTIONS Because SLS OSS463B is a replacement N0 diskette, the SLS takes effect upon system installation. See the SCO OpenServer product documentation for software installation instructions. If one of the updated drivers is required for installation, the included BTLD will also be needed. To use the BTLD, enter "link" at the boot prompt and follow the instructions. Enter the driver name from the list below when prompted for the package name. If more than one driver is required, use quotes around the names; for example, "slha wd". Name Description ---- ------------------------------ alad Adaptec 294x (7870 & 7880 Chip) arad Adaptec 274x (7770 Chip) mdac Mylex Disk Array Controller slha Symbios Logic (formerly NCR MPD) 53c8xx Host Adapters wd Enhanced IDE, ATAPI Interface (for tapes and CD-ROMs) PROBLEMS ADDRESSED BY SLS OSS463B 1. During the installation of SCO OpenServer 5.0.4, if any attempt is made to select a SCSI adapter, other than the default for the location of the CD-ROM drive, the adapter selection is ignored and the CD-ROM is not recognized. Because of this, it was not possible to install from CD-ROMs attached to any SCSI adapter other than the default (root drive) SCSI adapter without a boot string. This replacement N0 diskette includes a new install routine which correctly recognizes the specified CD-ROM SCSI adapter. 2. The installation fails because the SCSI HBA that is used is not supported by the SCO OpenServer 5.0.4 driver. The replacement N0 and BTLD contain updated alad, arad, mdac, slha and wd drivers. 3. Choosing the SCSI HBA replacement option during a BTLD installation fails if the CD-ROM and root disk drive are not attached to the same SCSI adapter. The replacement N0 diskette contains an updated boot-time linker. 4. Mounting a secondary IDE hard disk may cause a kernel panic. If you have questions regarding this SLS, or the product on which it is installed, please contact your software supplier. We appreciate your business. SCO Support Services