What Dell Host Adapters are supported by the percraid Host Bus Adapter driver version 7.3.17? KEYWORDS: openserver v5 osr5 DELL adapter drivers bus pci advanced hardware supplement ftp downloadable percraid scsi SATA fibre mpt VERSION 7317 RELEASE: SCO OpenServer Enterprise System Release 5.0.6a, 5.0.7 SCO OpenServer Desktop System Release 5.0.6a, 5.0.7 SCO OpenServer Host System Release 5.0.6a, 5.0.7 HARDWARE: Dell PE1650, SCSI RAID ROMB, U160 Dell PE2650, SCSI RAID ROMB, U160 Dell PE2400, SCSI RAID ROMB, U160 Dell PE2450, SCSI RAID ROMB, U160 Dell PE2550, SCSI RAID ROMB, U160 Dell PE2500, SCSI RAID ROMB, U160 Dell PE4400, SCSI RAID ROMB, U160 Dell PE4500, SCSI RAID ROMB, U160 Dell PERC 2/QC, SCSI RAID Four channel, U160 DELL PERC 320DC, SCSI RAID, Single channel, Ultra320, 66Mhz PROBLEM: What DELL Host Adapters are supported by the percraid Host Bus Adapter driver? NOTE: This driver package is to be installed on: SCO OpenServer 5.0.6a, 5.0.7 SOLUTION: This driver package is available at the following URL: ftp://ftp.sco.com/pub/openserver5/507/drivers/percraid7317 Modification History ******************** 09/27/04 New driver. ******************** To install these drivers, follow these instructions: 1. Aquire the driver from the ftp address listed above. - Download the btld image to a directory/file on your machine. For example, /tmp/percraid_7.13.17.btld. - Verify the downloaded image using sum. sum -r /tmp/percraid_7.13.17.btld.img This should return: 20895 2880 /tmp/percraid_7.13.17.btld.img - Format a floppy disk using the format command. - Copy the downloaded image to the floppy: dd if=/tmp/percraid_7.13.17.btld.img of=/dev/fd0 bs=18k - Verify the copied floppy image using sum: sum -r /dev/fd0 This should return: 20895 2880 /dev/fd0 2a. Fresh Installation on Primary Drive - Insert a boot disk or Installation CD and boot the system. - At the boot prompt, type: defbootstr link=percraid - Press and continue with normal installation. 2b. Installation on a Secondary Drive - Boot and Login normally. - Mount the floppy image: mount -r /dev/fd0 /mnt - Use the BTLD Install script to install the driver: /etc/btldinstall /mnt Once the kernel has been relinked, reboot the host and verify that is initializing the card. The boot time banner should look something like: %adapter 0xec00-0xecff 11 - type=percraid ha=0 slot=0 bus=0 id=7 fts=sto When the adapter is installed and the boot-time banner is properly displayed, you may use the appropriate mkdev script to add a disk, tape, or cdrom to the SCSI and/or Fibre Channel Bus.