Drivers for the Novell NE2000, NSC NE2000plus InfoMover, IBM LAN Adapter ... KEYWORDS: openserver v5 osr5 nat adapter drivers bus pci 5.0.0 5.0.2 5.0.4 5.0.5 ahs advanced hardware 5.2 supplement ftp downloadable network novell ne2000 nsc ne2000plus infomover ibm lan adapter for ethernet ne2000 compatible RELEASE: SCO OpenServer Enterprise System Release 5.0.0, 5.0.2, 5.0.4, 5.0.5 SCO OpenServer Desktop System Release 5.0.0, 5.0.2, 5.0.4, 5.0.5 SCO OpenServer Host System Release 5.0.0, 5.0.2, 5.0.4, 5.0.5 SCO Internet FastStart Release 1.0.0, 1.1.0 HARDWARE: Novell NE2000 NSC NE2000plus InfoMover IBM LAN Adapter for Ethernet (NE2000 Compatible) NOTE: The compatible bus type for this driver is ISA. PROBLEM: What drivers are available for the Novell NE2000, NSC NE2000plus InfoMover and IBM LAN Adapter for Ethernet (NE2000 Compatible)? NOTE: This driver package is to be installed on: SCO OpenServer 5.0.0: Release Supplement 5.0.0d (rs500d) Networking Supplement 1.0.0 (net100) SCO Advanced Hardware Supplement (AHS) 5.2 In this order. SCO OpenServer 5.0.2: SCO Advanced Hardware Supplement (AHS) 5.2 (available on 5.0.2 CD media) SCO OpenServer 5.0.4: No additional supplements are necessary SCO OpenServer 5.0.5: No additional supplements are necessary SCO Internet FastStart Release 1.0.0, 1.1.0 Supplements are downloadable from ftp.sco.com. You may install the 'Network' portion of SCO AHS 5.2 or just the Network Configuration Manager portion to obtain the minimal necessary networking software to configure this driver. SOLUTION: These drivers are available at the following URL: ftp://ftp.sco.com/pub/drivers Modifications ************* 5.0.5a - Base 5.0.5b - Correct possible system lockup under high load due to internal buffer overflow. To install these drivers, take the following steps: - Log in as root. - Install SCO AHS Release 5.2 if not already installed. For SCO OpenServer 5.0.0 and 5.0.2 only. - Download the volume image(s) to your machine to a directory, for example, /tmp/vol. - Run 'custom' and select 'Install New'. Install from your host machine using 'Media Images'. - Give the directory name where the volume images have been downloaded, for example, /tmp/vol. - Complete the installation and exit custom. - Install the network adapter hardware into your computer. - Run 'netconfig' and configure the new adapter.