Title: README.TXT file for Unixware 1.1 Intel EtherExpress(TM) PRO/10 driver Date : 25-Jul-95 Rev : 1.2 --------------------------------------------------------------- This file accompanies eprou11.pkg, which is in datastream format. !!!IMPORTANT NOTES!!! -- Before installing in a UnixWare system, you'll need to set the IO Address and Interrupt (IRQ) of the adapter and turn off "Plug and Play" on the adapter. Insert the Intel Configuration and Drivers disk and from the DOS-prompt type: SOFTSET2 Remember to write down the IO Address and IRQ. You'll be asked for these values during installation. Turn off Plug and Play in the Advanced Options section of SOFTSET2. -- After following the installation instructions below, remember to run: /etc/confnet.d/configure -i This configures the new network hardware on your system. INSTALLATION INSTRUCTIONS ========================= There are two ways of installing driver support for the EtherExpress PRO/10: 1. Install from the command line, or 2. Install from the X Window environment Installing from the command line is usually the quickest. Installing from the Command Line -------------------------------- First, you must be the root user before installing. Then follow these steps: 1) Copy eprou11.pkg to the /tmp directory on your hard drive using either cp or doscp. 2) Run the pkgadd command: pkgadd -d /tmp/epro11.pkg 3) The installer should ask you for information about your EtherExpress PRO/10 adapter: - The first screen asks how many adapters are in your system and how you want the adapters to respond to IOCHANNEL READY. Use the default of LATE. - The second screen asks for the IO Address, Interrupt (IRQ), and Connector type settings for each PRO/10 adapter. Use the IO Address and IRQ setting you wrote down when running SOFTSET2. 4) Configure the IP parameters for the EtherExpress PRO/10 by typing: /etc/confnet.d/configure -i NOTE: If you install multiple EtherExpress PRO/10 adapters in your system after installing a single adapter, you must remove and then reinstall the epro11 package. Installing from the X Window environment ---------------------------------------- Follow these steps: 1) Copy the epro11.pkg file to a /tmp directory using either cp, doscp, or the window interface. 2) In a command window, type: pkgtrans /tmp/epro11.pkg /var/spool/pkg eprou11 This converts the file from datastream format to file system format. 3) Go to the 'System Setup' folder (make sure you are logged in as the system owner) and run 'Appl-n Setup.' Follow this path: - 'View' - 'Uninstalled Appl'ns' - 'Other' - Select the directory where 'epro11' is listed - Select 'epro11' again - 'Application' - 'Install' 4) The installer should ask you for information about your EtherExpress PRO/10 adapter: - The first screen asks how many adapters are in your system and how you want the adapters to respond to IOCHANNEL READY. Use the default of LATE. - The second screen asks for the IO Address, Interrupt (IRQ), and Connector type settings for each PRO/10 adapter. Use the IO Address and IRQ setting you wrote down when running SOFTSET2. 5) Configure the IP parameters for the EtherExpress PRO/10 by typing: /etc/confnet.d/configure -i NOTE: If you install multiple EtherExpress PRO/10 adapters in your system after installing a single adapter, you must remove and then reinstall the epro11 package.