System Security Enhancement (SSE) SSE071 - 08-Aug-2000 Problem: Setuid programs that can invoke scohelp do not remove privilege before doing so providing the scohelp instantiation with the same access privileges as the invoking program. Patch: This patch is applicable to all OpenServer releases 5.0.0 through 5.0.6. This patch contains replacement binaries of the following components: /usr/bin/X11/scohelp Installation: 1. We reccommend you drop into single user mode to install this SSE (though this is not enforced). You must at least kill all invocations of scohelp that may be running. 2. Uncompress and extract the SSE into a temporary directory of the server (eg. /tmp/sse071). # uncompress sse071.tar.Z # tar xvf sse071.tar 3. Execute the install script. Follow the instructions at the prompt. # ./install-sse071.sh Note: "Warning" messages simply explain that because a specific file was not found on the current server, it was not replaced. If a system has custom binaries or paths, this patch may not succeed. 4. Clean up. A backup of the orginal binaries will be saved in: /opt/K/SCO/sse/sse071 The following files will be left over after patch installation and can be removed: ./install-sse071.sh ./sse071.files.tar The following files will be left over after patch installation and can be moved to an archival directory in case the patches are needed again: ./sse071.tar ./sse071.doc Disclaimer: SCO believes that this patch addresses the reported vulnerabilities. However, in order that it be released as soon as possible, this patch has not been fully tested or packaged to SCO's normal exacting standards. For that reason, this patch is not officially supported. Official supported and packaged fixes for current SCO products will be available in due course.