System Security Enhancement (SSE) SSE070b - 4-Aug-2000 Problem: This sse contains a replacement binary that corrects the two vulnerabilities described by CERT advisory CA-2000-13. These vulnerabilities may allow privileged execution of arbitrary code. SSE070b is a recut of SSE070 to correct problem in the install script that prevent installation on SCO OpenServer 5.0.0, 5.0.2 and 5.0.4. Patch: This patch is only for OpenServer systems running release versions 5.0.5 or earlier This patch contains replacement binaries of the following components: /etc/ftpd Installation: 1. We advise that you should be in single user mode to install this SSE. 2. Uncompress and extract the SSE into a temporary directory of the server (eg. /tmp/sse070). # uncompress sse070b.tar.Z # tar xvf sse070b.tar 3. Execute the install script. Follow the instructions at the prompt. # ./install-sse070.sh Note: "Warning" messages simply explain that because a specific file was not found on the current server, it was not replaced. If a system has custom binaries or paths, this patch may not succeed. 4. Clean up. A backup of the orginal binaries will be saved in: /opt/K/SCO/sse/sse070 The following files will be left over after patch installation and can be removed: ./install-sse070.sh ./sse070.files.tar The following files will be left over after patch installation and can be moved to an archival directory in case the patches are needed again: ./sse070b.tar ./sse070b.doc Disclaimer: SCO believes that this patch addresses the reported vulnerabilities. However, in order that it be released as soon as possible, this patch has not been fully tested or packaged to SCO's normal exacting standards. For that reason, this patch is not officially supported. Official supported and packaged fixes for current SCO products will be available in due course.