System Security Enhancement (SSE) SSE068d - August 7 -2000 Problem: When /etc/sysadm.d/bin/userOsa gets a bad command, it does a Tcl dump to ./debug.log, retaining its setgid "auth" perms. A simple symlink e.g. `ln -s /etc/shadow ./debug.log` allows users to overwrite anything group "auth" can write. Patch: This patch is for OpenServer systems running release versions 5.0.0 - 5.0.5 This patch contains replacement binaries of the following components: 1. Buffer overflows in: /etc/sysadm.d/userOsa Installation: 1. You must be root to install this SSE. 2. Uncompress and extract the SSE into a temporary directory of the server (eg. /tmp/sse). # uncompress sse068d.tar.Z # tar xvf sse068d.tar 3. Execute the install script. Follow the instructions at the prompt. # ./install-sse068.sh Note: "Warning" messages simply explain that because a specific file was not found on the current server, it was not replaced. If a system has custom binaries or paths, this patch may not succeed. 4. Clean up. A backup of the orginal binaries will be saved in: /opt/K/SCO/sse/sse068 The following files will be left over after patch installation and can be removed: ./install-sse068.sh ./postinstall-sse068.sh ./sse068.files.tar The following files will be left over after patch installation and can be moved to an archival directory in case the patches are needed again: ./sse068d.tar ./sse068d.ltr Disclaimer: SCO believes that this patch addresses the reported vulnerabilities. However, in order that it be released as soon as possible, this patch has not been fully tested or packaged to SCO's normal exacting standards. For that reason, this patch is not officially supported. Official supported and packaged fixes for current SCO products will be available in due course.