System Security Enhancement (SSE) SSE050c - 17-Jul-2000 Problem: sse050c is a replacement for sse050b of 1 March 2000 that corrects a problem with file permissions on the replacement file in /usr/bin/X11. sse050b was a replacement for sse050 of 24th December 1999. It differs from that one by an update to the usrOsa binary to correct reference to a nonexistant SSO path on OpenServer 5.0.5 and by an update to the libXt files. Several vulnerabilities in OpenServer have been reported to allow unauthorised administrative access. Patch: This patch is only for OpenServer systems running release versions 5.0.5. This patch contains replacement binaries of the following components: 1. Buffer overflows in: /usr/mmdf/chans/smtpsrvr /etc/killall /etc/popper /usr/bin/mscreen /usr/bin/rlogin /bin/su /usr/lib/sysadm/termsh /usr/lib/libX11.so.5.0 /usr/lib/libXt.so.5.0 /usr/lib/libXmu.so.5.0 /usr/lib/libXaw.so.5.0 /usr/lib/libX11.a /usr/lib/libXt.a /usr/lib/libXmu.a /usr/lib/libXaw.a /usr/bin/X11/xterm /usr/bin/X11/xload /usr/bin/X11/scoterm /usr/bin/X11/scolock /usr/bin/X11/scosession /usr/bin/X11/scologin /usr/lpd/remote/rlpstat /usr/lpd/remote/cancel /usr/lpd/remote/lpmove 2. Algorithmic vulnerabilities in: /etc/sysadm.d/bin/userOsa: Can improperly write to privileged files /usr/bin/X11/Xsco: Can improperly read privileged files (also buffer overflows) /bin/hello: Can improperly acess privileged devices Allows transmission of dangerous characters /bin/write: Allows transmission of dangerous characters /bin/login: Corrupt /etc/dialups causes login failure Insufficient error checking Installation: 1. You must be in single user mode to install this SSE. 2. Uncompress and extract the SSE into a temporary directory of the server (eg. /tmp/sse050). # uncompress sse050c.tar.Z # tar xvf sse050c.tar 3. Execute the install script. Follow the instructions at the prompt. # ./install-sse050.sh Note: "Warning" messages simply explain that because a specific file was not found on the current server, it was not replaced. If a system has custom binaries or paths, this patch may not succeed. 4. Clean up. A backup of the orginal binaries will be saved in: /opt/K/SCO/sse/sse050 The following files will be left over after patch installation and can be removed: ./install-sse050.sh ./postinstall-sse050.sh ./sse050c.files.tar The following files will be left over after patch installation and can be moved to an archival directory in case the patches are needed again: ./sse050c.tar ./sse050c.ltr Disclaimer: SCO believes that this patch addresses the reported vulnerabilities. However, in order that it be released as soon as possible, this patch has not been fully tested or packaged to SCO's normal exacting standards. For that reason, this patch is not officially supported. Official supported and packaged fixes for current SCO products will be available in due course.