System Security Enhancement (SSE) 015 - 15th September 1998 Problem: A security vulnerability has been discovered in the ToolTalk database server (part of the UnixWare 7 CDE software) - this vulnerability is described in CERT advisory CA-98.11. These updated binaries correct this vulnerability. Patch: Replacement binaries are supplied for SCO UnixWare 7 only - other SCO operating systems are not affected. Installation: Perform the following steps logged in as root: 1. Create a temporary directory, and copy sse015 into it: # mkdir /tmp/sse015 # cp sse015.tar.Z /tmp/sse015 2. Extract files from the tar file: # cd /tmp/sse015 # uncompress sse014.tar.5 # tar xvf sse015.tar 3. An install script is supplied which executes the following commands: mv -i /usr/dt/bin/rpc.ttdbserverd /usr/dt/bin/rpc.ttdbserverd.old copy -mo rpc.ttdbserverd /usr/dt/bin/ mv -i /usr/dt/bin/ttdbck /usr/dt/bin/ttdbck.old copy -mo ttdbck /usr/dt/bin/ mv -i /usr/dt/bin/tttar /usr/dt/bin/tttar.old copy -mo tttar /usr/dt/bin/ pkgchk -a -f TEDdesk New binaries are provided for the ttdbck, tttar and rpc.ttdbserverd commands in /usr/dt/bin. The old versions are preseved in that directory with a '.old' extension. The pkgchk utility is called to set the file attRibutes. Execute this install script with the command: # sh install.sh Note - pkgchk can display verification errors on files supplied in this SSE when run after it has been installed. This due to the changed size and contents of these files - it is expected and should be ignored. 4. Remove the /tmp/sse015 directory. 5. Shut down and reboot your system, so that the new version of rpc.ttdbserverd is used. Disclaimer: SCO believes that this patch addresses the reported vulnerability. However, in order that it be released as soon as possible, this patch has not been fully tested or packaged to SCO's normal exacting standards. For that reason, this patch is not officially supported. Official supported and packaged fixes for current SCO products will be available in due course.