System Security Enhancement (SSE) 014b - 6th October 1998 Problem: A security vulnerability has been discovered in University of Washington imapd v4.0. This updated version corrects that vulnerability. Patch: Replacement binaries are supplied for each of the following SCO operating systems: - SCO UnixWare 7 - SCO OpenServer 5.0.5 Note that previous versions of SCO OpenServer, and all other SCO operating systems, are not affected as University of Washington imapd is not included in those releases. The UnixWare 7 replacement binary was included in the previous version of SSE014 (17th July 1998) - if you have already installed SSE014 on your UnixWare 7 system, it is not necessary to install SSE014b. Installation: Perform the following steps logged in as root: 1. Create a temporary directory, and copy sse014b into it: # mkdir /tmp/sse014b # cp sse014b.tar.Z /tmp/sse014b 2. Extract the files from the tar file: # cd /tmp/sse014b # uncompress sse014b.tar.Z # tar xvf sse014b.tar 3. Move the existing imapd aside: # mv /etc/imapd /etc/imapd.old 4. Install the replacement imapd and set the correct file ownership and permissions: - For SCO OpenServer 5.0.5: # copy -m imapd.osr5 /etc/imapd # chown bin /etc/imapd # chgrp bin /etc/imapd # chmod 755 /etc/imapd - For SCO UnixWare 7: # copy -m imapd.uw7 /etc/imapd # pkgchk -a -f base Note - pkgchk can display verification errors on files supplied in this SSE when run after it has been installed. This is due to the changed size and contents of these files - it is expected and should be ignored. 5. The replacement binary is now installed - it is not necessary to reboot your system. Disclaimer: SCO believes that this patch addresses the reported vulnerability. However, in order that it be released as soon as possible, this patch has not been fully tested or packaged to SCO's normal exacting standards. For that reason, this patch is not officially supported. Official supported and packaged fixes for current SCO products will be available in due course.