Dear SCO Customer, The enclosed Support Level Supplement (SLS) xnx252 contains replacement SCSI drivers for the ones that were supplied with SCO XENIX 386 Operating System Release 2.3.2GT. The new drivers reduce disk access times by better utilizing firmware features on the Adaptec 1540 series SCSI host adapters. To install SLS xnx252, take the following steps: (1) Reboot your system and enter System Maintenance Mode. (2) Insert the enclosed disk in the primary floppy drive and close the door. (3) At the prompt, type: /etc/install (4) Answer 'y' to the question "First Floppy? (y/n)". (5) If the Link Kit is not installed, you will be prompted: "The Link Kit is only partially installed. Do you wish to install it now? (y/n)" Answer 'y' to this question. You cannot install SLS xnx252 unless the Link Kit is installed. You will need the operating system installation disks, as well as your operating system Serial Number and Activation Key to install the Link Kit. Follow the directions at each of the prompts to install the Link Kit. The installation of SLS xnx252 will continue after you have finished installing the Link Kit. (6) If the Link Kit is installed, you will be asked: "Do you wish to create a new kernel now? (y/n)" Answer 'y' to this question. (7) After the new kernel is created, you will be asked: "Do you wish this kernel to boot by default? (y/n)" Answer 'y' to this question. (8) Answer 'n' to the question "Next Floppy? (y/n)". (9) When you are finished, remove the disk from the drive. At the prompt, type: /etc/haltsys to reboot your system. If you ever have to reinstall your Link Kit, you will also have to reinstall SLS xnx252. If you have any questions, please call our Customer Services Department at (800) 347-4381. SCO Customer Service is available Monday through Friday, 6 A.M. to 5 P.M., Pacific Time. We appreciate your business. SCO Support Services