Dear SCO Customer, Enclosed find your copy of Support Level Supplement (SLS) xnx232. This SLS will allow you to install SCO XENIX 386 Operating System Release 2.3.2 for computers based on Micro Channel Architecture (MCA) on systems using IBM ESDI drives manufactured by Seagate Technologies (for example, ST 177i 60 MB). To use SLS xnx232, replace the N1 diskette provided with your original distribution with the N1 diskette that is supplied with this SLS. Install the Volume 1 diskette with custom after the installation process (detailed instructions follow). 1. Start the installation by booting from the new N1 diskette. (SCO ESDI Supplement to SCO XENIX - volume N1) Follow the instructions displayed on the screen. If you are asked during the installation process to relink the kernel, you must say no, as you cannot do so until after the Volume 1 diskette has been installed. Again, DO NOT RE-LINK THE KERNEL UNTIL AFTER YOU HAVE INSTALLED Volume 1 below. Complete the installation normally as instructed and reboot the system. 2. Install the Volume 1 diskette using "etc/custom": - Type "/etc/custom" (The custom menu will appear) - Choose option 4 'Add a Supported Product' (Installing Custom data files) - You will be prompted to 'Insert distribution Volume 1 and press '. Insert the diskette labeled SCO ESDI Supplement to SCO XENIX V Volume 1 and press . - The custom sub-menu will appear. Choose option 1 'Install one or more packages' - You will see the following: Name Inst Size SCO ESDI Supplement packages ---------------------------------------------------------------------- ALL No 234 Entire ESDI Supplement - You will be prompted for the packages to install, type "ALL" - You will see the message: 'Insert SCO ESDI Supplement volume 1 and press ' - You should already have the diskette in the drive; press - You will see the following messages: Extracting files ... Modifying Link Line ... Relinking the kernel ... Backing up /xenix as /xenix.old Installing xenix on hard disk. You will need to shut down and reboot the system in order to load the newly installed /xenix into memory Checking file permissions ... - Next you will see the Custom menu, enter "q" to quit. 3. At the prompt, enter the command 'haltsys' to reboot the system and activate the changes. Your ESDI SLS xnx232 is now installed correctly. If you have any questions, please call our SCO Customer Services Department at (800) 347-4381. SCO Customer Services is available Monday through Friday, 6:00 to 5:00 P.M., Pacific Time. We appreciate your business. SCO Support Services.