Dear SCO Customer: Enclosed is a disk containing a driver for the Western Digital WD1007A hard disk controller card. This driver corrects hard drive access problems encountered with this card in SCO XENIX Releases 2.2.3 and 2.3 on both 286 and 386 AT class machines. The directions for installation are as follows: 1) Reboot your system and enter System Maintenance Mode. 2) Insert the enclosed disk in the primary floppy drive and close the door. 3) Type /etc/install at the prompt. 4) Answer 'y' to the question "First Floppy? (y/n)". 5) If the Link Kit is not installed, you will be prompted: "The Link Kit is only partially installed. Do you wish to install it now? (y/n)" Answer 'y' to this question. You cannot install this Supplement unless the Link Kit is installed. You will need the Operating System installation disks, along with your Operating System Serial Number and Activation Key to install the Link Kit. Follow the directions at each of the prompts to install the Link Kit. The installation of this Supplement will continue after you have finished installing the Link Kit. 6) If the Link Kit is installed, you will be asked: "Do you wish to create a new kernel now? (y/n)" Answer 'y' to this question. 7) After the new kernel is created, you will be asked: "Do you wish this kernel to boot by default? (y/n)" Answer 'y' to this question. 8) Answer 'n' to the question "Next Floppy? (y/n)". 9) When you are finished, remove the disk from the drive and type: /etc/haltsys at the prompt to reboot your system. If you ever have to reinstall your Link Kit, you will have to reinstall this Supplement also. If you have any questions, please call our Customer Services Department at (800) 626-4381. SCO Customer Service is available Monday through Friday, 6 A.M. to 5 P.M., Pacific time. We appreciate your business. SCO SoftCare Support Services