Dear SCO Customer, The enclosed Support Level Supplement (SLS) unx277 corrects a problem with the ESC Host Adapter Supplement Release 1.2.0. This version of the ESC Host Adapter Supplement is only applicable to SCO UNIX System V/386 Release 3.2 Operating System Version 2.0, Open Desktop Release 1.0 and Open Desktop Release 1.1. The problem is very rare but may, under some circumstances, cause your machine to panic. The panic is only likely to occur if your machine is swapping very heavily. SLS unx277 may only be applied to systems that have previously been installed with Release 1.2.0 of the ESC Host Adapter Supplement. It is not applicable to machines that have SCO UNIX System V/386 Release 3.2 Operating System installed with ESC Host Adapter Supplement Release 1.1.0. The directions for installation are as follows: (1) Reboot your system and enter System Maintenance mode. (2) Insert the enclosed disk in the primary floppy drive and close the door. (3) Type "/etc/xinstall". (4) Answer 'y' to the question "First Floppy? (y/n)". (5) You will see the message "Updating Host Adapter Driver..." before you are asked: "Do you wish to create a new kernel now? (y/n)". Answer 'y' to this question. You may ignore the following warning message if it appears: "warning: no dma channel specified for scsi device: prefix oha". (6) After the new kernel is created, you will be asked: "Do you wish this kernel to boot by default? (y/n)". Answer 'y' to this question. (7) You will then be asked: "Do you wish to rebuild the kernel environment? (y/n)". Answer 'y' to this question. (8) Answer 'n' to the question "Next Floppy? (y/n)". The installation is now complete. Reboot your system to start running off the new kernel. If you have any questions, please call our SCO Customer Services Department at (800) 347-4381. SCO Customer Service is available Monday through Friday, 6:00 A.M. to 5:00 P.M., Pacific Time. We appreciate your business. SCO Support Services